Instructions / Assembly

PAGE 1
BALLAST COMPATIBLE HYPERION. DUAL-END LED T5 TUBE INSTALLATION INSTRUCTIONS 3 waning RISK OF ELECTRIC SHOCK. DISCONNECT MAIN POWER AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLING OR SERVICING THE FIXTURE. DO NOT INSTALL THIS FIXTURE IN A PRE HEAT LUMINARY. NOT SUITABLE FOR ENCLOSED LUMINARIES. THIS FIXTURE ONLY OPERATES ON ELECTRON C BALLAST. IF THE FIXTURE DOES NOT LIGHT WHEN THE LUMINARY [S ENERGIZED, REMOVE FIXTURE FROM LUMINARY AND CONTACT THE L AMP MANUFACTURER OR QUALIFIED ELECTRICIAN. RISK OF FIRE.
PAGE 2
HYPERION. INSTALLATION INSTRUCTIONS BALLAST COMPATIBLE DUAL-END LED 15 TUBE ‘D INSTALLATION INSTRUCTIONS 1. Make sure the power is OFF. 2. Turnover lens or diffuse (if applicable} 3. Remove existing fluorescent tubes from the luminary. 4. Bring LED tubes to luminary and insert the tube pins into the tube holders. 5. Rotate the LED tube until the tube locks in place. Ensure that the LED tube front points away from the back of the luminary. 6. Place lens or diffuse back in place (if applicable) 7.