Corporation Network Router User's Manual

Chapter 2
Installation Procedures
This section contains inportant information that will help properly install ICE 5000 and 5500 terminals.
Power-Up the ICE Terminals
Use the following procedures to power up the ICE 5000 or 5500 terminals.
Step-by-Step
To power up the ICE terminal:
1. Connect the +24 Vdc power cable from the AC Adaptor to the three-pin terminal socket labeled
POWER on the back panel of the ICE 5000 or 5500 terminals.
2. Plug the AC Adaptor into a 110-Volt grounded power receptacle. Be sure the connector is firmly
seated. When the power is connected successfully, the terminal beeps twice and then performs a
self-test and diagnostic routine.
Figure 2-1. ICE 5000 power socket
Power socket