Corporation Network Router User Manual

IN-tact 1101 Software Configuration Guide 59
System Status Screen
Field/Button Description
Current IN-tact 1101 Status:
Current Status There are two possible displays:
OK: indicates that the device has been configured and is working
correctly
Not Configured: indicates that the IN-tact 1101 has not been
properly configured. Go to System Setup and configure the device.
Current Mode Indicates whether the IN-tact 1101 is operating in “normal” mode or
“install” mode.
Install mode is used to test terminal communications and should not
be left on. Go to Control Panel > System Operations to disable
install mode if it is on.
System Time Shows you the current time set for the IN-tact 1101.
Uptime Total time that the device has been powered on and operating.
Terminals Enabled Indicates the number of terminals configured. Terminals are
configured on the Terminal Port Settings screen.
Terminals Active Indicates the number of configured terminals that are responding to
poll and operating correctly. For more detailed information, see the
Terminal Status screen.
Host Ports Enabled Indicates the number of host port connections that have been
enabled.
Product Information:
Product Part Number Part number (the combination of hardware and software) of the
IN-tact device
Platform Part Number Part number of the complete IN-tact 1101 without a firmware load
Serial Number Unique serial number of this IN-tact device
Hardware Part Number Part number of the base printed circuit board within the IN-tact 1101
Firmware Name Filename of the firmware currently loaded on the IN-tact 1101
Firmware Part Number Version of the firmware currently loaded on the IN-tact 1101
Build Date/Time When the firmware was compiled
Build Number Reference number assigned to the firmware
File Size (bytes) Actual size of the image file in bytes