Corporation Network Router User Manual

Configuring the IN-tact 1101 Configuration Screens
34 Hypercom Corporation
Terminal Port Settings Screen
On the navigation tree, click IN-tact Setup > Application Setup > Terminal Port. The Terminal
Port Settings screen appears:
Use this screen to set the communication parameters for connection to your HLAN terminal
network. Your settings here should match the configuration of your terminal network. You are
required to configure at least one terminal for the IN-tact 1101 to be operational. You cannot
permanently save the configuration until you do so.
NOTE: Click Save and Continue or Apply and Restart as appropriate. Keep in mind that your
changes are not written to persistent memory until you click Apply and Restart.
Field/Button Description
HLAN Speed Use the drop-down list to select either 19200bps (default) or 4800
bps. The speed selected should match speed set in the terminals.
Enabled By default, all terminal addresses are disabled. Use this series of
checkboxes to enable any terminal address not being used. You can
also use this feature to temporarily disable a terminal that is not
responding to poll if it is affecting network performance.
Description Type a brief text description of each terminal on the HLAN network,
such as “Register 1”, “Drive-thru”, etc. 32 characters are accepted.
CU Address A listing of valid HLAN polling addresses. Make certain that the
Enabled checkbox is selected and there is a description for each
terminal address in use at this location. All unused addresses should
be disabled so they are not polled.