User Manual

WR2 Wireless Sensor • www.rainbird.com/WR2
7
Saving, Resetting
and Restoring
Settings
Save Contractor Default
Settings
Once the Controller
Interface is completely
programmed, press
+
and right arrow buttons
simultaneously for ve
(5) seconds to save
contractor default setting.
All programmed icons will
ash in unison one time to
indicate program is saved.
Reset Contractor Default
Settings
The Contractor default setting stores
programming details related to rainfall and
temperature set points.
Reset and save programming details in
accordance with Section
and
.
Reset Contractor Default
Settings
If this programming is inadvertently changed,
it is simple to restore.
Press
+ and – buttons
simultaneously for ve
(5) seconds, or until the
screen goes blank. When
icons reappear, contractor
default settings are
restored.
Restore Standard Setting
Press the – and left arrow
buttons simultaneously
for ve (5) seconds, or
until the screen goes
blank, to cancel the
Contractor default setting
and restore the ”Standard
Setting”: temperature
37°F (3°C), rain fall ¼”
(6mm) and “programmed
irrigation” mode. When
icons reappear, ”Standard
Setting” is active.
Select the Sensor
Location
The communication range for the
WR2 Wireless Sensor is 700 feet
(213.4 meters).
• A blinking light on the bottom of the
Sensor indicates signal strength for 20
minutes immediately following successful
pairing. The Sensor updates its signal
strength every 3 seconds (i.e. 1 blink =
reliable signal strength, series of 4 blinks
= strongest signal strength). If the signal
strength is not optimum in one location,
try another location. Even as little as a few
feet dierence in placement can improve
signal strength.
• Select a mounting location where the rain
sensor will receive direct rainfall. Make
sure the sensor extends beyond the roof
line, tree limbs and any other obstructions.
Install the Rain Sensor in an area that
receives as much rain and sunlight as the
landscape. Be sure to mount the sensor
above spray from the sprinklers.
Signal Sensor LED
GOOD
Install
1-4 Blinks
POOR
DO NOT install
Does not blink