User Manual
WR2 Wireless Sensor • www.rainbird.com/WR2
6
5. The Sensor is successfully paired to
the Controller Interface when the
“Sensor Indicator / Pairing Status” icon
stops ashing. Once paired, sensor
signal strength and battery life are
communicated via the Controller Interface
icons. Additionally, a blinking light on
the bottom of the Sensor indicates signal
strength for 20 minutes immediately
following successful pairing. These “self
test” features are an indication that your
WR2 Wireless Sensor is operational.
Programming the
Set Points
The WR2 Wireless Sensor allows the contractor
to establish rainfall and temperature set
points appropriate for local environmental
and soil conditions. Alternately, the contractor
may elect to use the “Standard Setting”:
temperature 37°F (3°C), rain fall ¼” (6mm) and
“programmed irrigation” mode. The ”Standard
Setting” is programmed at the factory and is
active after successful pairing.
Rainfall Set Point
1. Push left or right
arrow on keypad to
navigate to the Rainfall
Indicator icon.
2. When the Rainfall
Indicator icon ashes,
press the
+ / – button
on the keypad to set
programming details.
Each press of the
button adjusts the set
point. Select from six
(6) set points ranging
from 1/8” (3mm) to
1/2” (13mm).
3. Press the left or right
arrow to accept
programming details
and to navigate to
next icon.
Temperature Set Point (Rain/
Freeze Sensor only)
1. Push left or right arrow
on keypad to navigate
to the Temperature
Indicator icon.
2. When the Temperature
Indicator icon ashes,
press the
+ / – button
on the keypad to set
programming details.
Select one of three
temperature settings:
33°F (0.5°C), 37°F (3°C),
or 41°F (5°C).
3. Press the left or right
arrow to accept
programming details
and to navigate to
next icon.
Programming
Irrigation Modes
1. Push left or right arrow
on keypad to navigate
to the Irrigation Mode
icon.
2. When the Irrigation
Mode icon ashes,
press the
+ / – button
on the keypad to set
programming details.
Manually set one of
three irrigation modes.
See Irrigation Modes.
3. Press the left or right
arrow to accept
programming details
and to navigate to
next icon.