User Manual

WR2 Wireless Sensor • www.rainbird.com/WR2
2
WR2 Components
■
1 Controller Interface
■
2 Sensor
■
3 Battery Cassette and
Lithium CR2032 Battery
■
4 Sensor Mounting Bracket Assembly
■
5 Mounting Hardware
■
6 User’s Manual
■
7 Quick Reference Guides
■
8 WR2 Quick Reference Labels
NOTE: Tools needed for installation: drill, drill
bit, and Phillip’s head screwdriver
■
1
■
4
■
5
■
6
■
7
■
8
■
3
■
2
WR2 Benets
• All settings are programmed through the
Controller Interface device
• Large easy to understand icons communicate
irrigation mode and sensor status
• Sensor LED indicator enables one-person
setup, reducing installation time
• Battery is easy to install / replace
• Aesthetic appearance - no external antennas
• Easy to install, self-levelling sensor bracket
mounts to at surfaces or rain gutters
• “Quick Shut O ” interrupts active irrigation
cycle during a rain event
• Enhanced antenna array provides superior
signal reliability that overcomes most line
of sight obstructions
Mounting the
Controller Interface
Choose a location near the
irrigation controller / timer.
!
The cable harness is 30
inches (76.2 cm) long, so
before mounting the device,
ensure the wires easily reach
the irrigation controller’s
connection terminals.
• Select a at surface adjacent
to the irrigation controller.
• For best performance, the
Controller Interface should
be installed at least ve feet
(1.5m) above the ground.
• It is recommended that
the Controller Interface be
installed away from sources of
electrical interference (such
as transformers, generators, pumps, fans,
electrical meter boxes) and metal objects to
maximize communication range.
• Use the mounting hardware supplied.
Attach the Controller Interface to the wall.