User Manual

WR2 Wireless Sensor • www.rainbird.com/WR2
8
Sensor Mounting
Instructions
This section provides detailed ins-
tructions on how to install the sensor.
Sensor Bracket Assembly
Components:
Attaching the bracket to a
gutter.
Slide the top portion of the attachment
bracket over the lip of the gutter. Rotate the
bracket downward over the gutter as shown
in the following installation steps.
Attaching the bracket to a
Flat Surface.
Use the supplied hardware to mount the
attachment bracket to a at surface such as a
wall or fence.
mounting
bracket
gutter
■
1
■
2
Installing the Sensor in the
attachment bracket.
To insert the Sensor in the attachment bracket
you must rst remove the Sensor cap. Hold
the sensor body in one hand; gently twist
the cap with your other hand. Slide the neck
of the sensor up through the opening of the
extension arm. Reinstall the cap. A clicking
sound indicates that the two latches on the
sensor body have fully re-engaged the cap.
Using Multiple
Controller Interface
Units
Up to four (4) Controller Interface units can be
paired to one (1) sensor.
1. Ensure all Controller Interface Units are
powered up.
2. Synchronize the Sensor to the rst
Controller Interface in accordance with
Section
.
3. As you approach the second Controller
Interface, remove the battery cassette
from the Sensor. Push both arrow buttons
simultaneously on the second Controller
Interface. Wait 5 seconds. Reinsert the
battery into the Sensor. The Controller
Attachment
Bracket
Extension
Arm
■
1
remove cap
■
3
replace cap
■
2
insert