Use Manual

ManualsBrandsHYPER TOY ManualsAutomotiveRC TRUCK

Direction

Trimmer

On/Off

USE AGE: 8+

NOTICE:

BATTERY USE

INDICATOR

Turn left/

Turn right

Forward/Backward

Battery charging and installation method

Rotate the tabs to fasten the battery cover.

Safe use of batteries

Maintenance and repair

2.4Ghz

Press at the

bottom and drive

at high speed.

Forward

Slow down to avoid rollover

accident when entering the curve.

7.4V

7.4V7.4V

(INCLUDED)

(NOT INCLUDED)

Welcome to our company’s world of toys! To ensure an enjoyable experience with this toy, read

the following instructions—which will give you a proper understanding of the product and its

correct use—before use. Please hold on to this manual.

This toy is not suitable for children under the age of 36 months due to the risk of swallowing small components. They are a choking

hazard.

· Keep these instructions for future reference. They contain important information. We have the right to improve/modify our product

specifications without notice.

· Use under the supervision of adults.

· Do not change or modify this product. If you modify the product, you may not use it.

1. Flip the remote-control car’s switch to the On position.

2. Operate the control trigger to make the remote-control car drive forward or backward and to the left or right.

3. If the remote-control car does not drive in a straight line, adjust the direction trimmer beneath the car.

4. Flip the switch of the remote-control car and controller to the Off position after use.

1. Charge under adult supervision.

2. Remove the rechargeable battery from under the car to charge.

3. Remove dead batteries from the remote-control car and controller.

4. Turn the remote-control car switch to the Off position before installing the battery.

5. When installing the batteries in the battery compartment according to the instructions, be careful not to install the (+) and (-) electrodes

in the wrong position. Make sure that the battery’s electrodes are installed correctly.

6. Do not recharge non-rechargeable batteries.

7. The power terminals must not be short-circuited.

8. If it has been a long time since you have used the remote-control car, remove the batteries from the remote-control car and controller.

9. Do not expose the battery to fire: It may explode or leak.

10. Different types of batteries or old and new batteries should not be mixed.

11. Only use the recommended batteries or their equivalent.

12. The batteries should be checked regularly for leaks.

13. Keep this manual for use when needed. This manual has important information.

1. Do not put the toy in the water: This will damage the electronic components. (If you buy an amphibious vehicle, you can drive it in the

water.)

2. Do not allow the wires or power connector to come into contact with water.

3. Wipe the surface with a damp cloth.

4. Do not expose toys to high temperatures, humidity or direct sunlight.

5. If you don't expect to play for a long period, remove the batteries.

When the car is moving, do not touch its four wheels with your hands to avoid damaging it.

Avoid playing beside the road or in dangerous places. This will prevent accidents.

Common troubleshooting method

Problem.

Why the car will not

drive.

The car is hard to

control, or the

remote control

distance is limited.

Cause of problem. Solution

1. You did not flip the car’s or the controller’s switch to the

On position.

2. The battery is not installed correctly.

3. The car’s battery power is low.

1. Flip the car’s or controller’s switch to the On position.

2. Install the battery correctly in the controller.

3. Replace the car’s battery or charge rechargeable battery.

1. Use the car elsewhere or wait for others to stop using the

frequency.

2. Replace the controller’s or remote-control car’s battery or

charge the rechargeable battery.

1. People nearby are using the same or a close frequency.

2. The controller or car does not have enough power.

Do not play with your remote-control car in wastewater.

1. When using the battery for the first time, charge it before use. For the first two charges, the charge time will be at least 8 hours for

the first charge and 4 hours for the second charge. Do not overcharge. Charging for a long time will not increase power.

2. Insert the battery cable connector into the charger’s cable port. Then plug the charger into an indoor power outlet.

3. Use the rechargeable battery and charger that we have configured for this product.

4. Regularly check toy, batteries, charger wires, plugs, and other parts. If these parts are damaged, they cannot be used again. They

need to be repaired before they can be used.

5. Please use high-quality AA batteries for the best user experience of this product.

· Make sure the power switch is in the On position.

When you are operating the remote-control car, if the

power switch is in the Off position, it will not function.

· When the remote-control car veers left when you are

trying to drive in a straight line, adjust the direction

trimmer slightly to the right until the remote-control car

has the correct trajectory.

· When the remote-control car veers right when you

are trying to drive in a straight line, adjust the direction

slightly to the left until the remote-control car has the

correct trajectory.

1. Install the battery according to the positive and

negative electrodes in the battery box.

2. Install the battery cover as indicated by the

arrows in the above figure.

3. Put rechargeable batteries into the battery box.

4. Turn the four rotating tabs to fasten the battery

cover.

5. Batteries should be charged under adult

supervision.

1. You must completely install the battery cover before using the remote-control car.

2. The battery and body-battery interface must not be exposed to water.

3. When the USB is charging, the red light will flash, and the red light will be off when the battery is fuly charged.The

red light is on when the battery is disconnected from the power supply.

OPERATING TIPS

INSTRUCTION MANUAL -1:10 SCALE AMPHIBIOUS RC TRUCK

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a residen-

tial installation. This equipment generates uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions,may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interfer-

ence by one or more of the following measures:

This device contains licence-exempt transmitter(s)/receiver(s) that comply

with Innovation, Science and Economic Development Canada’s licence-ex-

empt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause

undesired operation of the device.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an

uncontrolled environment.

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

210610HY