User Manual

ASSEMBLY ASSEMBLYASSEMBLY

1. ASSEMBLING THE BLOWER TUBE

Slide the lower blower tube to upper blower tube.

2. ASSEMBLING THE BLOWER

Press the tube release button, so that you can slide

blower tube to the motor housing.

3. ATTACHING THE EXTENSION CORD

HT19-401-003-21

Electric Blower

7.5

PAGE 1
7.5 HT19-401-003-21 A Electric Blower 1 2 3 ASSEMBLY ASSEMBLY ASSEMBLY 1 2 1 1. ASSEMBLING THE BLOWER TUBE Slide the lower blower tube to upper blower tube. 2. ASSEMBLING THE BLOWER Press the tube release button, so that you can slide blower tube to the motor housing. 3.
PAGE 2
7.5 ON HT19-401-003-21 A Electric Blower 4 5 6 OPERATION OPERATION OPERATION OFF 4. STARTING & STOPPING Starting Move the On/Off switch to the “I” or “II” On position. Stopping Move the On/Off switch to the “0” Off position. 5. USING THE BLOWER USER TIPS - Adjusting the Blowing Speed (I or II) according to the desired working condition. - Hold the blow tube approximately 8” above the ground when operating the tool. - Use a sweeping motion from side to side.