Submittal

Contractor: P.O.:
Engineer:
Project Name: Unit Tag:
04/14 5 Page _____ of _____
Single Phase Soft Starters
The manufacturer works continually to improve its products. As a result, the design and specifi cations of each product at the time of order may be changed without notice. Purchaser’s approval of this data set signifi es that the equipment is acceptable under the
provisions of the job specifi cation. Statements and other information contained herein are not express warranties and do not form the basis of any bargain between the parties, but are merely the manufacturer’s opinion or commendation of its products.
SureStart Compatibility Guide
Nominal Supply Voltage*
Single Phase
SS0B12-20 SS1B08-16 SS1B16-32
115/60/1 ●
208-230/50-60/1 ●●
Full Load Amperage, FLA (Typical) 12-20 08-16 16-32
* - Voltage/Hz/Phase
11/21/13
Wiring Schematics
RUN WINDING
RUN CAPACITOR
ACTIVE (T2)
START WINDING
NOT USED
COMPRESSOR
COMMON
R
S
C
RUN
CAP
T2L2
T1L1
COMP
CONT
COMP
CONT
SureStart
RUN WINDING
RUN CAPACITOR
ACTIVE (T)
START WINDING
NOT USED
COMPRESSOR/MOTOR
COMMON
R
S
C
RUN
CAP
L T
N
COMP
CONT
SureStart
230V with Two Pole Contactor
115V/230V with Single Pole Contactor
CAUTION: SureStart must be installed in
a location that ensures that the external
heat from a hot gas line, compressor
discharge piping, or similar heat source will
not cause damage. Minimum 3” [76mm]
clearance is recommended.