Spec Sheet
Table Of Contents
- Introduction
- Background
- In-Rush Current
- SureStart In-Rush Reduction
- Hard Start kits vs. SureStart
- The SureStart Difference
- Increasing Utility Regulation
- Off-Grid & Generators
- Generator Sizing Methods
- SureStart Operation
- Led Flash Codes
- SureStart Operation Flow Chart
- Model Nomenclature
- Selection Example
- Dimensional Data
- Approved Mounting Positions
- Characteristics
- Application Notes
- SureStart Compatibility Guide
- Wiring Schematics
- Declaration of Conformity
- Definitions
Single Phase Soft Starters
Page 17
Wiring Schematics
SureStart Compatibility Guide
Nominal Supply Voltage*
Single Phase
SS0B12-20 SS1B08-16 SS1B16-32
115/60/1 ●
208-230/50-60/1 ●●
Full Load Amperage, FLA (Typical) 12-20 08-16 16-32
* - Voltage/Hz/Phase
11/21/13
RUN WINDING
RUN CAPACITOR
ACTIVE (T2)
START WINDING
NOT USED
COMPRESSOR
COMMON
R
S
C
RUN
CAP
T2L2
T1L1
COMP
CONT
COMP
CONT
SureStart
RUN WINDING
RUN CAPACITOR
ACTIVE (T)
START WINDING
NOT USED
COMPRESSOR/MOTOR
COMMON
R
S
C
RUN
CAP
L T
N
COMP
CONT
SureStart
230V with Two Pole Contactor
CAUTION: SureStart must be installed in
a location that ensures that the external
heat from a hot gas line, compressor
discharge piping, or similar heat source will
not cause damage. Minimum 3” [76mm]
clearance is recommended.
115V/230V with Single Pole Contactor