Datasheet

Rev. 1.0 / Jul. 2012 38
Slew Rate Definitions for Single-Ended Input Signals
See 7.5 “Address / Command Setup, Hold and Derating” on page 134 in “DDR3 Device Operation” for sin-
gle-ended slew rate definitions for address and command signals.

See 7.6 “Data Setup, Hold and Slew Rate Derating” on page 142 in “DDR3 Device Operation” for single-
ended slew rate definition for data signals.
Slew Rate Definitions for Differential Input Signals
Input slew rate for differential signals (CK, CK and DQS, DQS) are defined and measured as shown in table
and figure below.
Notes:
The differential signal (i.e. CK-CK and DQS-DQS) must be linear between these thresholds.
Differential Input Slew Rate Definition for DQS, DQS and CK, CK
Differential Input Slew Rate Definition
Description
Measured
Defined by
Min
Max
Differential input slew rate for rising edge
(CK-CK
and DQS-DQS)
VILdiffmax VIHdiffmin [VIHdiffmin-VILdiffmax] / DeltaTRdiff
Differential input slew rate for falling edge
(CK-CK
and DQS-DQS)
VIHdiffmin VILdiffmax [VIHdiffmin-VILdiffmax] / DeltaTFdiff
Delta
TFdiff
Delta
TRdiff
vIHdiffmin
vILdiffmax
0
Differential Input Voltage (i.e. DQS-DQS; CK-CK)
Differential Input Slew Rate Definition for DQS, DQS# and CK, CK#