User Manual

8. Restores the default serial port rate 38400 and no checked
GPIO37 pin holding low level above 2S can restore the default serial port rate
and return to AT + BAUD=38400,0 + return line.
Please take attention that changes or modification not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
The module is limited to OEM installation ONLY
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to
remove or install module.
When the FCC identification number is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains FCC ID: 2AZ6I-ML601” and the information should be also contained in
the devices’ user manual.