Manual

9
Res-Up
®
Feeder Installation Instructions
1. Remove top cover, fill the Res-up
®
Feeder (plastic container) to the top with water so that the wick retaining clip, tube
and wick are wetted. Allow to soak for 15 minutes or more.
2. Empty water and pull tube and wick through Feeder until slack is removed from inside. The outlet end tube and wick
must be below the bottom level of the Res-up
®
Feeder.
3. Fill Feeder with Res-up
®
Cleaner to ‘Fill Line’ on label.
4. Replace cover on Feeder and automatic feeding will occur in a few hours.