User guide

5
Setting the Regeneration Frequency (CC)
Your water softener is factory set to regenerate every day. All the
tabs on the skipper wheel are pushed outwards. You must push
the tabs in towards the center of the wheel on the days
regeneration is not desired. If your softener was sized correctly,
the following table can be used to help determine the frequency of
regeneration or the number of tabs that should be pushed
outwards on the skipper wheel. Use this table as a guide.
Individual circumstances will require more or less frequent
regenerations.
Frequency of Automatic Regeneration
Calendar Clock Models Only - Figure 3
Grains of
Hardness 1-5 6-10 11-15 16-20 21-25 26-30 31-35 36-40 41-45 46-50 51-55 56-60
No. of
People Regeneration Frequency - No. of Tabs Pushed Outwards
2 111111 2 222 33
3 112233 3 333 44
4 122333 3 344 66
5 223344 4 466 66
6 223344 6 6661212
72334466612121212
8 2 3 3 4 6 6 6 12 12 12 12 12
9334466121212121212
10 34 4 6 612121212121212
Salt Settings are factory set and should not need adjustment
5600CC/MI-835-50...................5 lbs
5600CC/MI-844-75...................7 lbs
5600CC/MI-948-100...............10 lbs
5600CC/MI-1035-100.............10 lbs
5600CC/MI-1047-125.............13 lbs
5600CC/MI-1054-150.............15 lbs
5600CC/MI-1252-200.............10 lbs
5600CC/MI-1450-250.............13 lbs