Manual

11
CLEANING, SANITIZING, AND CARTRIDGE REPLACEMENT PROCEDURE
19. CAUTION: Do not remove protective plastic bag from replace-
mentlter/membranecartridgesuntilsoinstructed.
 Install“O”ringsintolterhousings.Opentopoflterbagenough
toexposeltercapand“O”ringgrooves.Placeasmallamount
of “O” ring lubricant on surface of each “O” ring.
20. CAUTION:Tightenlterhousingsbyhandonly.Donotusetools
as they will over-tighten and damage housings. Take care not to
cut or pinch o-rings.
CAUTION:RefertoFigure8forlocationofeachcartridge.
 Installlterandmembranecartridges.Holdcartridgebyits
protective plastic bag and insert cartridge into manifold turning
it1/4turnasitenterstheport.Slidebagfromcartridgeanddis-
card.Replaceeachlterhousingaseachcartridgeisinstalled.
21. Turn feed water valve slowly to open position.
22.Conrmsystemisproducingwater.Unitwillbesendingrinse
water to drain.
Optional Smartap
®
Water Quality Monitor
TOREPLACEBATTERY:PerformSteps23–29
NOTE: Replace battery with a new alkaline 9-volt battery.
23. CAUTION: Wiring within module cover connects monitor compo-
nents.Ifwires,circuitboard,orconnectionsaredamagedand/
or wetted, monitor will not function.
Remove module cover by gently lifting manifold cover up and
away from manifold body.
24. Disconnect battery. The battery connection is a snap type con-
nector (Figure 9).
25. Remove battery by sliding it out of its holder.
26. Slide new battery into its holder.
27.CAUTION: Verify battery connector alignment before making
connection (Figure 9).
Connect battery by pressing clip onto battery terminals.
NOTE: Release button immediately after light illuminates. Test is
toconrmbatteryconnection,notwaterquality.
28.Testbatteryconnectionbyactivatingmonitor.Presspushbutton.
If an indicator light illuminates, connection is good.
29. Replace manifold cover by gently pushing manifold cover onto
manifold until it snaps into place.
30. Open product water faucet. Let water flow until all air has been
expelled from the system.
31. Close product water faucet. Wait 30 minutes, check connec-
tions for leaks, and correct if necessary.
Icemaker/Extra point of use: Check lines for leaks.
32.Allowstoragetanktollovernight.
33. WARNING: DO NOT USE THE FIRST FULL STORAGE TANK OF WATER
 Discard(todrain)rstfulltankofwaterbyopeningproductwa-
ter faucet until water flow stops, then close faucet. This flushes
sanitizing solution from system.
Icemaker:Lettray/binllwithicecubes.Discardallicecubes
to drain. This flushes sanitizing solution from lines to icemaker.
Replacedeliverydevicelter(ifapplicable).
34. System is ready to use. Should there be any after taste or odor,
drain storage tank and repeat Steps 32 and 33.
FIGURE 9: SMARTAP
®
BATTERYCONNECTIONS
DO NOT USE THE FIRST
FULL STORAGE TANK OF WATER
Allowreservoirtollovernight.
Dispense this water to drain.
This process removes sanitizing solution from system, sanitizes
ttingsandtubing,andsendssolutiontodrain.