Installation Sheet

– 4 –
FIGURE 5B
FIGURE 5A
INSTALL BATHTUB
Apply generous bead of adhesive or silicone to the
bottom of the tub supports (Figure 5A).
Then apply a bead of tub and tile caulk or silicone
around the edge of the base (Figure 5B).
12
10
1
1
FIGURE 6
Carefully set tub into position (Figure 6
) and connect
the drain hardware (previously installed).
D980-CAP
2-7/8”
5/16”
1-1/2” OD Tubing
20 ga.
Cut to Fit Tub Dimensions
Overflow O-Ring
792A-BJ
®
U
P
C
C
WB 17 GA
24”
D980-RING
FIGURE 7
OVERFLOW INSTALL
1
3
Apply a thin bead of silicone around face of the
overflow O-ring. Mount the D980-RING using the
provided screws. (Figure 7) Adjust the ball-joint to
the contours of the tub and tighten the ring.
14
Slide the escutcheon onto the tube and extend it
through the floor and into the P-Trap