Installation Sheet

– 3 –

Please refer to www.hydrosystem.com for videos on how to install your bathtub and get specific dimensions on your

model bathtub

BATHTUB INSTALLATION

FIGURE 1

PREPARATION

Clean, level, and prepare the floor for installation.

Place the unit in the exact installed position on the floor

and trace the outline of the bath with a pencil or any

erasable marking (Figure 1). Templates for Freestanding

bathtubs come with the tub.

Determine the location of the drain pipe on the floor by

taking measurements of the drain location underneath

the unit (Figure 2).

Note: Drain, waste locations, and trim options

vary by model.

FIGURE 2

Using a blanket, cardboard, or other clean protective

surface, turn the unit on its side so that the unit is

properly supported during drain installation.

Clean the drain hole area in preparation of setting the

drain. The area should be dry and free of any debris.

INSTALL DRAIN HARDWARE

Measure and dry fit all connections. Cut tubes as necessary.

Primer then glue drain elbow and female adapter. Primer

and glue elbow to tee and adapter. (Figure 3)

Apply a thin ring of silicone around the underside of the

strainer. Position gasket between the drain ell and the

bottom of the bath. Begin threading the strainer into the

drain ell. (Figure 3)

Insert the handle of a pliers into the drain and secure

strainer to ell. Remove excess sealant. (Figure 4)

Silicone

”

FIGURE 3

FIGURE 4