Instruction Manual

6
Rev.A of 20210624
When installed as an anchor point on a flat surface or on one side of a peaked roof, the connecting fall arrest subsystem
must not extend over the peak of the roof to the other side.
When working on the opposing roof surface, installation of an additional Reusable Roof Anchor is required on that side.
Anchor must be positioned to apply load in the long axis of the anchor bracket.
After removal of the Reusable Roof Anchor, roof surface may require repairs. It is the responsibility of the installer to
make applicable repairs to the roof materials.
Reusable Roof Anchor can be used on a maximum roof slope of 12/12 pitch.
Attachment:
Center on the ridge of roof framing assembly. Position the anchor on the roof such that the holes along the center of
the legs are centered directly over the center of the roof framing member. The roof anchor must be positioned over top
of previously secured roof sheathing (do not attach directly to rafter or truss).
Installation of 14427
The 6 center holes and 1 row of the outer holes on each leg must be used. The 6 center holes must be centered on the
framing section and the 5 outer holes must penetrate through substrate. At least 22 nails must be used as shown below.
It was fixed using nails measuring 92mm length & 3.8mm diameter.
Installation of 14428
All holes on each leg must be used, so 18 nails must be used as shown below. It was fixed using nails measuring 92mm
length & 3.8mm diameter.
5. Loading Direction Limitation
75mm
45mm