Install Instructions

MOUNTING THE CONTROL

STEP 1

Two mounting positions are available on the

back of the control (Fig. 1). Select which of the two positions

(2 knockouts) is best for the location of the control. Remove

he knockout.

STEP 2 Place control on the well. While holding box

against well nut, tighten well clamp screw. (Fig. 2)

BACK OF HYDROSTAT BOX

FIG. 1

FIG. 3

FIG. 2

NOTE: In the case of space restrictions, the HydroStat con-

trol may be mounted in a horizontal orientation without any

loss of function. Hydrolevel recommends vertical mounting,

when possible, for proper orientation of LED display.

STEP 3 Insert sensor ALL THE WAY into well through

the knockout (A or B) you have chosen. (Fig. 3)

IMPORTANT Make sure that the immersion well or Electro-Well™ is installed on the boiler manufacturerʼs

designated temperature limit control tapping. Note: If installing an Electro-Well, pipe sealing compound should be

used. Teflon tape is not recommended.

REMOTE MOUNTING

The following kits are available separately for mounting

the HydroStat control box in a remote location. Each kit

includes mounting hardware and a remote sensor.

Part No. Description

48-101 HydroStat Remote Mount Kit

with 24" sensor

48-102 HydroStat Remote Mount Kit

with 48" sensor