User Guide

INSTRUCTIONS
3
grill, secure with the phillips screw on band.
7. Use 2 tapping screws to mount the bracket
in the desired posion. Firmly push the
assembled fan onto the mounng bracket.
OPERATION
1. Plug the power supply plug into a outlet.
2. To adjust fan speed, pull the switch pull (right
string). The switch knob will rotate through
all three speeds and back to OFF.
3. To make the fan oscillate, pull the oscillaon
pull (le string).
CLEANING THE BLADES
1. Always unplug the fan before cleaning.
Simply li the clips on ring of the grills and
remove the front grill.
2. Use a so cloth, moistened with a mild soap,
to clean fan and grill. DO NOT use abrasive
cleaners.
3. DO NOT immerse fan in water and
never allow water to drip into the motor
component.
4. DO NOT use gasoline, paint thinner or other
chemicals to clean the fan.
USER SERVICING INSTRUCTIONS
This fan features a fused safety plug that is
designed to cut o electric current to the fan if
an electrical fault occurs. Please see below for
more informaon on how to properly use your
fan and replace the safety plug fuse, if needed.
IMPORTANT: To avoid risk of re, replace fuse
only with a 2.5 Amp, 125 Volt fuse.
1. Grasp plug and remove from the receptacle
or other outlet device. Do not unplug by
pulling on cord.
2. If your fan loses power and you suspect that
the fuse on your fan has blown, you should
rst remove the spare fuse holder aached
to the cord plug. Remove the spare fuse from
the plasc spare fuse holder, and set the
spare fuse aside.
3. You can gain access to the blown fuse by
sliding open the door on the side of the plug.
Slide the door outward unl the blown fuse
is fully visible.
4. Remove the blown fuse and snap the
replacement fuse into place. Fully close the
fuse door by sliding back into place. Discard
the blown fuse. The plug should now be
ready for normal use.
5. If the replacement fuse blows, a short-circuit
may be present and the product should
be discarded or returned to an authorized
service facility for examinaon and/or repair.
Slide
door
open
Fuse
1. Front grill
2. Fan blade
3. Rear grill
4. Motor cover
5. Base
6. Power cord
7. Switch pull
8. Oscillaon pull
9. Switch knob
10. Plasc nut
11. Blade cap
12. Support Band