Owner's manual
VWHDOWK52100
™
Setup
(cont)
to the 'o' position as soon as you see water ow from the blue puried water line.
This will pressurize the system and is a good way to make sure that all ttings
and connections are secured properly and that there are no leaks. It is also a good
way to make sure that the automatic shut-o is working properly, meaning the
black drain line is shutting o. If there are problems of any kind please contact
Hydro-Logic directly at 888-426-5644.
1RWH It may take up to 24 hours of running the system for the PPM & pH
of the puried water to stabilize.
Source/Inlet Line (White)
Purified Water Line (Blue)
Waste Water Line (Black)
Upon intial start up of system, slowly turn the source water on until both the
carbon and sediment lters have water in the housings. Next, open source
water up all the way (do not exceed 80 psi). Flush the system for 30-45
minutes when the system is new and/or when you replace your membrane.
This will ush out the food grade preservative in the membrane .
The rst time you run water through the system please turn the inline shut-o valve