Installation Guide & Owner's Manual 350 Encinal Street, Suite 170 Santa Cruz, Ca 95060 Mattison Lane, Suite P: 2825 888-426-5644 / F:103 831-336-9840 Santa Cruz, Ca 95065 www.hydrologicsystems.com P: 888-426-5644 / F: 831-336-9840 www.eco-spring.
Introduction to the EcoSpringTM System Congratulations on your purchase of the EcoSpringTM reverse osmosis system, welcome to the future of home drinking water purification You have purchased the most advanced, efficient and easy to maintain reverse osmosis system available. When properly maintained, this system will provide you with years of trouble-free service.
Warranty The Limited Warranty extends to the original purchaser of the system. This warranty covers all parts and factory labor needed to repair any Manufacturer-supplied item that proves to be defective in material, workmanship or factory preparation. The above-mentioned warranty applies for the first full calender year from date of purchase.
System Specifications Performance Specifications Production TDS Rejection Recovery1 Brine to Product Feed Water Requirements Membrane System w/Tank 40 GPD (151 LPD) 95% 26.3% 2.8:1 21.6 GPD (81.8 LPD) 95% 17% 4.86:1 Pressure Temp TDS Chlorine Turbidity SDI pH 40-80 psi (275 kPa - 552 kPa) 40°F - 100°F (4°C - 38°C) <2000 mg/L <1.0 mg/L <1 NTU <5 4-8 1 The percentage of the feed water available as reverse osmosis treated water under normal operating conditions.
Push Handle Airgap Faucet Determine the most practical under-the-sink location for placement of the EcoSpringTM system. Ensure that the location allows adequate access for cartridge replacement. 1. Place the system in the selected location. 2. Place the rubber seal (1) flush against the base of the faucet. 3. Insert faucet base assembly down through the sink hole. 4. From underneath the sink, push the 1/4” black drain tubing attached to the system onto the 1/4” fitting located on the faucet base. 5.
Feed and Drain Connection Feed Connection Note: The feed connection pictured on the box may be different from what is included with the system. 1. Locate and turn off the angle stop valve on the cold water line feeding the sink. This valve will usually be located under the sink on the pipe coming out of the wall. 2. When the angle stop valve is closed, relieve pressure in the line by opening the cold water tap on the sink. 3. Disconnect the feed line at the angle stop valve.
System Activation and Flushing System Activation and Inspection 1. Check all tubing connections to ensure they are firmly seated. CHECK TO SEE THAT THE CARTRIDGE RETAINER CLIP IS PROPERLY ENGAGED AND LOCKED. Failure to keep the retaining clip in place will result in accidental leaks and flooding. 2. Open the dispensing faucet at the sink. Close the tank shut-off valve. 3. Open the feed water valve to the system. Observe all tubing and connections for several minutes to detect any leaks.
Installation Checklist 1. System is located where it will not be subject to physical impacts or rough contact by heavy objects. 2. Feed water pressure to the unit is no less than 40 psi and no greater than 80 PSI. 3. Ensure the plastic retainer clip that holds the desalinator cartridge in place is fully engaged and locked in place. The slide locks must snap into place in the slots.
Maintenance Cartridge Replacement 1. Close the feed water shut-off valve. 2. Close the tank shut-off valve. 3. Open the dispensing faucet to relieve system pressure. Close dispensing faucet when flow has stopped. 4. Remove the cover from the front of the system. Remove the retaining clip. Pull the cartridge off the system evenly at top and bottom. Dispose of used cartridge. 6.
