Warranty

Caution! Wait 20 minutes before activating the fixture after maintenance work has been conducted.
• Regularly check the fixture for dust or dirt buildup. Clean if necessary.
• Contamination may cause overheating and decreased performance.
• Clean the inside of the reflector only with a soft, dry cloth.
• Clean the electric ballast and the outside of the fixture using a dry or damp cloth.
• Check the lamp monthly for discolorations or black markings. Always replace a damaged lamp.
• Regularly check the wiring of the fixture to ensure it is undamaged.
8.1. Placement and Replacement of the Lamp
Caution! Do not touch the lamp with bare hands as this will damage the lamp.
Always use a fabric glove to handle the lamp.
Note: The lamp must be replaced every year or after 5000 lighting hours, whichever one comes first.
• Hold the lamp with a fabric glove to prevent it from falling. Use a protective glove if the lamp is damaged.
• Align the pin of the lamp with two holes of the base, insert and screw the lamp into the base.
• Plug the fixture back into the mains.
8.2. Placement and Replacement of the Reflector
Note: You have to remove the lamp to replace the reflector.
Depending on the environment and contamination levels the reflector will degrade.
• Loosen the screw and ring on the top of the bracket.
• Remove the reflector.
• Place the new reflector, tighten the screws.
10. Storage and Disposal
• Store the fixture in a dry, clean environment.
• Do not dispose the fixture or any part of it as unsorted municipal waste - instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic equipment.
Caution! The lamps are chemical hazardous waste and must be delivered to the designated authorities.