Full Product Manual

Operating Instructions:
1. Make sure the power supply cord and lamp end are properly connected.
2. Ensure the bulb is properly seated in the socket assembly. It should be tight, but not stressed.
3. Always use a bulb centric to the highest output of the ballast (e.g. 315w bulb/315w ballast)
4. Confirm the ballast is not near any source of moisture or standing water.
5. Check the sealed bearing fan to confirm it is free from any obstruction. This should be periodically checked to make sure
it stays clear and clean.
6. Plug the power supply cord into an appropriate power supply.
7. After ignition, give your lamp a minimum of 30 seconds to reach full power.
8. Always allow the bulb to cool before re-striking the ballast; we recommend 15 minutes.
9. Ballast can be cleaned using a clean, dry towel. Should the ballast somehow become wet, turn off main power supply
and unplug the unit before attending to it.
10. Allow 10 seconds between power adjustments when using the Dimmer Switch. This will allow the ballast sufficient time
to gather electrical charge to increase wattage output.
Remember, safety first! Although incredibly rewarding, indoor growing can present dangerous situations. Never allow standing
water to be present, never hang a ballast from either the power or lamp cord, and always make sure your equipment is fastened
safely and securely. Your ballast does not require any switches or re-wiring to change voltage or bulb spectrum. Simply turn off
and unplug the unit and allow bulb to cool before changing cords or bulbs, respectively.