Full Product Manual

400W BALLAST
120V SETUP:
400W BALLAST
240V SETUP:
600W BALLAST 120V
SETUP:
600W BALLAST 240V
SET UP:
1000W BALLAST 120V
SETUP:
1000W BALLAST 240V
SET UP:
PLEASE MAKE SURE
THERE IS 7 AMP
OF ALLOWANCE PER
BALLAST/ BREAKER.
PLEASE MAKE SURE
THERE IS 5 AMP
OF ALLOWANCE PER
BALLAST/ BREAKER.
PLEASE MAKE SURE
THERE IS 10 AMP
OF ALLOWANCE PER
BALLAST/ BREAKER.
PLEASE MAKE SURE
THERE IS 7 AMP
OF ALLOWANCE PER
BALLAST/ BREAKER.
PLEASE MAKE SURE
THERE IS 15 AMP
OF ALLOWANCE PER
BALLAST/ BREAKER.
PLEASE MAKE SURE
THERE IS 10 AMP
OF ALLOWANCE PER
BALLAST/ BREAKER.
BALLAST
SPECIFICATION:
BALLAST
SPECIFICATION:
BALLAST
SPECIFICATION:
BALLAST
SPECIFICATION:
BALLAST
SPECIFICATION:
BALLAST
SPECIFICATION:
50% 1.68 AMP
50% 1.13 AMP
50% 2.68 AMP
50% 1.49 AMP
50% 4.72 AMP
50% 2.34 AMP
75% 2.5 AMP
75% 1.45 AMP
75% 3.78 AMP
75% 1.89 AMP
75% 6.64 AMP
75% 3.33 AMP
100% 3.75 AMP
100% 1.95 AMP
100% 5.48 AMP
100% 2.57 AMP
100% 8.74 AMP
100% 4.28 AMP
Warnings:
 NEVER stack multiple ballasts on top of each other, as this can also cause a fire or other damage.
 NEVER use a ballast that appears to be damaged or a ballast that you know has been dropped, shaken,
exposed to water, or otherwise damaged.
 NEVER attempt to plug in any bulbs or components to any other components that are already turned on or
have electricity running through them. The last step should always be to switch on the power.
 NEVER attempt to rapidly turn on and off the ballast or attached components (bulb, reflector). Ballasts and
components need to cool down for approximately 15 minutes before they can be turned back on. Failure to
do so can result in damaged components and is not covered under warranty.
 You should ALWAYS consult a certified electrician when setting up your lighting systems to ensure that you
are not overloading your circuits. Incorrectly wired systems and overloaded circuits can result in fires and
serious injuries.