Instructions / Assembly

How to Assemble
1. Use 28 sets wing screws and 12 nuts to attach the middle aluminum and side aluminum.
2. Use rest 18 sets wing screws and nuts to connect the middle steel plates to the side aluminum
reflector.
3. Finish the assembly and hang the reflector with rope hangers.
Lamp Installation
1. Open up both the cover of lamp holders.
2. Install the lamp after the lamp is locked by latch.
3. Once lamp is positioned correctly close the cover of the lamp holders to secure and lock the lamp in
place.
4. Installing the double ended lamp within the lamp holders shown in the following photos below.
Please note: During installation try to minimize excessive handling of the lamp to minimize fingerprints and
oils left on the lamp. If the lamp needs cleaning use a soft dry cotton cloth to wipe of finger prints or oils.
ATTENTION：Please make sure the wire of the lamp is straight when you install the lamp. If not, the lamp
will not connect securely with the socket.