Instructions / Assembly

2 / 4
2.2 Push the movable block in the direction of the arrow to the ends of the lamp
holders at both ends. (See Figure 3)
Figure 3
2.3 Press the square pressure-sealed parts at both ends of the lamp into the lamp
holder installation slot until the metal spring supports the lamp stably, and at the
same time, the electrode leads at both ends are placed in the metal clip inside the
lamp holder. This process must ensure that the electrode leads are straight. (See
Figure 4-6)
Correct operation
Figure 4
Wrong operation
Figure 5 Figure 6
The seal is placed incorrectly
The electrode lead is bent
The electrode leads are
not well twisted