Warranty

• Install the new lamp with getter near the ballast (C).
• Use a fabric glove to carefully press the lamp in the fitting until the springs hold the lamp.
• Close the cap of the lamp holders, make sure the cap of lamp holders are closed tightly (D).
• Plug the fixture back into the mains.
8.2. Placement and Replacement of the Reflector
Note: You have to remove the lamp to replace the reflector.
Depending on the environment and contamination levels the reflector will degrade.
• Loosen the two screws on the top of the bracket.
• Remove the reflector.
• Place the new reflector, tighten the screws.
9. Storage and Disposal
• Store the fixture in a dry, clean environment.
• Do not dispose the fixture or any part of it as unsorted municipal waste - instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic equipment.
Caution! The lamps are chemical hazardous waste and must be delivered to the designated authorities.
10. More other voltage items to consider.
[240V], [277V]
If you are interesting other voltage, please contact us for more information.