630W DOUBLE ENDED CMH COMPLETE GROW LIGHT SYSTEM [120-240V] USER MANUAL Enclosed Style Open Style
IMPORTANT PRODUCT INFORMATION READ IMMEDIATELY SAFETY FIRST! Failure to observe the following safety warnings may result in serious injury or death. Use all Hydro Crunch™ products only as directed. Failure to observe these safety warnings will result in a waiver of any and all liability on the part of Hydro Crunch™ its manufacturer, and resellers, and will void all warranties to the extent permitted by law. WARNINGS AND INSTRUCTIONS FOR USE: Disconnect power before re-lamping.
1. Introduction Thank you for purchasing our Hydro Crunch 630W DE CMH COMPLETE GROW LIGHT SYSTEM. This manual describes the mounting and installing of the fixture and also describes how to use the fixture. Mounting and installing of the fixture may only be executed by certified service personal. Please read and understand this manual completely before using the fixture. Only use the fixture as specified in this manual. 2.
5. Safety Recommendations and Warnings Warning! Carefully read the warnings below before using or working with the fixture! • Always adhere to the local rules and regulations when installing or using the fixture. • Do not use the fixture when either the lamp or the power cord is damaged. Replace the power cord only with original certified cords. • Do not expose the fixture to: Condensing humidity, heavy mist, fog or direct spray, temperatures outside the specified range, dust and contamination.
Caution! Do not touch the inside of the reflector and do not use water, abrasives or detergents to clean it. This will damage the reflective surface. Caution! Wait 20 minutes before activating the fixture after maintenance work has been conducted. • Regularly check the fixture for dust or dirt buildup. Clean if necessary. • Contamination may cause overheating and decreased performance. • Clean the inside of the reflector only with a soft, dry cloth.
• Install the new lamp with getter near the ballast (C). • Use a fabric glove to carefully press the lamp in the fitting until the springs hold the lamp. • Close the cap of the lamp holders, make sure the cap of lamp holders are closed tightly (D). • Plug the fixture back into the mains. 8.2. Placement and Replacement of the Reflector Note: You have to remove the lamp to replace the reflector. Depending on the environment and contamination levels the reflector will degrade.
11. More reflector style to consider. 12. If you are interesting other reflector style, please contact us for more information.
2 Year Limited Warranty Service If the product will not work after you have read the troubleshooting guide and practiced the troubleshooting options, you are advised to return the Hydro Crunch™ light system to the retailer you purchased it from. The dealer will be able to examine the light and test its components. If they are not able to repair the light, they will return it to us for examination and repair/replacement. Do not attempt to repair any product on your own, as serious injury or death may result.
