Installation Guide
Table Of Contents
- 1. INTRODUCTION
- If additional questions arise relative to this luminaire that this document or your supplier cannot answer, please refer then to:
- Architectural Technical Support – Hydrel (888) 834-5684, Press #5 for Hydrel
- 2. INSTALLATION
- 2.2 Secure AMHM to Mounting Accessory
- 2.3 Secure AMHM to Mounting Accessory
Installation Guide 7
AMHM
Installation Manual
NOTE: HYDREL RESERVES THE RIGHT TO MODIFY SPECIFICATION WITHOUT NOTICE.
Any dimension on this sheet is to be assumed as a reference dimension:
“Used for information purposes only. It does not govern manufacturing or inspection requirements.” (ANSI Y14.5-1973)
Model AMHM | 11/01/21 | REV -
©2019 Hydrel Rev. | One Lithonia Way, Conyers, GA 30012
Phone: 1800.705.SERV (7378) | www.hydrel.com
2.3 Secure AMHM to Mounting Accessory
Yoke Version -- Continuation
Aim the AMHM:
A. Loosen Yoke Lock center fastener on each
yoke lock.
B. Locate lock disengagement slots.
C. Insert large flat blade screwdriver into slots
and pull screwdriver handle away from the
AMHM’s body releasing the Yoke Lock.
D. Adjust the AMHM and re-tighten center Yoke
Lock fasteners (Torque to 25 in-lb).
Aim Individual Luminaire(s):
Loosen adjusting screw on Knuckle Assembly with Allen
Wrench (Do not remove adjusting screw completely). Tilt
Luminaire to desired angle. Tighten adjusting screw with
Allen Wrench, with care not to over tighten screw.