Product Manual
3
! CAUTION
• Do not tamper with red-painted ports. Cylinder mechanism is sealed and should only be repaired by qualied
technicians.
• Do not use mechanical means to force the cylinder valve - adjust by hand only. Do not tamper with cylinder valve
nut.
• Do not use HydrauLink™ with tractors larger than recommended category (ref. page 2).
• Do not attempt to connect HydrauLink™ with the tractor's hydraulic system.
MAINTENANCE
The HydrauLink™ requires no maintenance. Occassionally wipe with clean cloth to avoid accumulation of mud and
debris.
3. Adjust your implement. Adjust your HydrauLink™ by using your three-point system. To pitch forward, lower
your implement to the ground. Open the valve (counter-clockwise) and roll the tractor forward a few inches.
When the implement is pitched to the desired angle, close the valve (clockwise). To pitch backward, raise the
implement and open the valve slowly until you get the desired angle, then close the valve.
2. Attach to the Implement. Open the valve all the way (counter-clockwise). Firmly grip the HydrauLink™ and
pull out the cylinder rod (chrome part) so that about 1-1/2" of chrome is explosed. Close the valve nger tight
only. Grasp the HydrauLink™ and rotate (unscrew) to lengthen from the end attached to the tractor until the
cylinder ball socket will attach with a pin to your implement. Do not unscrew more than 4-1/2".
Note: If HydrauLink™ has not been used for a long period of time, adjustment may be difcult due to pooling of
uid. Manually extending and retracting the piston several cycles will restore normal function.