Manual

MODEL S6105
4” (100 mm) Discharge
4” HYDRAULIC SUBMERSIBLE
HIGH PERFORMANCE,
SOLIDS HANDLING PUMP
The S6105 is designed for applications
where high heads and the ability to
handle solids is required. A typical use
for this pump would be as a temporary
sewage lift station where force main
pressures are encountered.
FEATURES
D0413
167 Stock Street, Nesquehoning, PA 18240 Phone: [phone] Fax: [phone]
Website: www.hydra-tech.com E-Mail: [e-mail]
WEIGHT:..................................................... 605 lbs. (276 kg)
HEIGHT:.............................................................. 36" (91 cm)
WIDTH (@ widest point):.................................... 25" (64 cm)
DISCHARGE:...................................... 4", 150# ANSI Flange
INLET:................................................. 4", 150# ANSI Flange
SOLIDS HANDLING:........................................... 3" (75 mm)
HOSE PORTS:......1-1/4" Code 61 Flange or 1-1/2" NPT (F)
PUMP BODY:...................................................... Ductile Iron
IMPELLER:.......................................................... Ductile Iron
WEAR RING........................................................ Ductile Iron
SHAFT:.............................................17-4 PH Stainless Steel
SHAFT SEAL:............................................... Silicon Carbide
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:................................. Max 70 GPM (265 LPM)
OPERATING PRESSURE:............. Max 2500 PSI (170 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
SPECIFICATIONS
Specifications are subject to change without notice
•
Balanced High Efficiency Two Vane
Closed Channel Impeller
•
Will pass 3" (75 mm) semi-solids
•
Variable Speed hydraulic drive provides
a wide range of performance
•
Oil Lubricated Seals (can run dry)
•
High Efficiency Balanced Vane
hydraulic motor
•
Can be bolted directly into a pipeline or
used as a booster pump
•
Safe Hydraulic Drive can be used where
electric power is hazardous or
impractical
•
Operates with our HT100 to HT150
power units or other hydraulic power
sources capable of flows of 50 - 70 GPM