Manual

MODEL S3SHR
3” (75 mm) Discharge
3” HYDRAULIC SUBMERSIBLE
SHREDDER PUMP
The S3SHR is designed to
continuously rip and shear solids with
a 360° shredding action. The smaller
size allows for use in tight spaces.
For municipal , industrial, agricultural
and institutional waste applications.
A guide rail assembly is available for
stationary applications.
FEATURES
•
Open-Vane Shredder Impeller with
Tungsten Carbide Cutting Tip
•
Hardened Macerator Suction Plate
•
Oil Lubricated Seals (can run dry)
•
Variable Speed hydraulic drive
•
Versions for Portable or Fixed Installations
•
Safe Hydraulic Drive can be used where
electric power is hazardous or impractical
•
Dependable gear type hydraulic motor
•
Operates with our HT10 to HT20 power
units or other hydraulic power sources
capable of flows of 6 - 10 GPM
C0413
167 Stock Street, Nesquehoning, PA 18240 Phone: [phone] Fax: [phone]
Website: www.hydra-tech.com E-Mail: [e-mail]
WEIGHT:........................................................ 73 Lbs. (33 kg)
HEIGHT:........................................................... 18.5" (47 cm)
WIDTH (w/Discharge elbow):........................ 15 1/4" (39 cm)
(Across Volute).................................. 9 1/2" (24 cm)
DISCHARGE:........................................................ 3" NPT(F)
SOLIDS HANDLING:........................................... 3" (75 mm)
HOSE PORTS:............................................ 5/8 (-10) SAE(F)
PUMP BODY:...................................................... Ductile Iron
IMPELLER:.......................................................... Ductile Iron
SHREDDER BLADE:................................ Tungsten Carbide
SHAFT:.......................................................... Stainless Steel
SHAFT SEAL:................................ (Upper) Carbon/Ceramic
(Lower) Silicon Carbide
ELASTOMERS:......................................................... Buna N
HYDRAULIC OIL:................. 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:.................................. Max. 10 GPM (38 LPM)
OPERATING PRESSURE:............ Max. 2600 PSI (177 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
SPECIFICATIONS
Specifications are subject to change without notice