Installation Manual Owner's manual

Installation Manual
© Hydra-Flex Inc 2011
- 5 -
Electrical Connections
Signal Power Connections select from the option below
that fits the version you purchased
Air pilot valves
o Connect your signal wires to the terminals on the air
solenoids
Pin 1 = ground
Pin 2 = positive
Pin 3 = negative
Pin 4 = ground
Air pilot valves with field wires
o Connect the first black wire to positive
o Connect the other black wire to negative
o Connect the green wire to ground
Electric solenoid valves
o Connect your signal wires to the terminals on the
solenoids
(see above diagram)
Electric solenoid valves with field wires
o Connect the first black wire to positive
o Connect the other black wire to negative
o Connect the green wire to ground
M12 block
Manifold Port or Use
Main Trunk Cable
Wire Color
Green/Yellow
Blue
Brown
White
Green
Yellow
Grey
Pink
Red
Pump Power Connectionsselect from the option below that fits
the version you purchased
Wire each leg of the power from your starter to the pump