Operating Manual User guide

Operating Manual

- 7 -

Triple Foam Setup (for MD5 if ordered with extra regulators)

If your MD5 panel was ordered with 3 air valves and 5 air regulators or with 5 air valves and 7 air regulators the

below instructions will show you how to setup your triple foam.

3 Valve / 5 Regulator MD5 Panel

• Your triple foam has been setup from the factory to be in port 3

• Insert your triple foam manifold into position 3 with your selected injectors already inserted

• On the side of the panel the 3

, 4

, and 5

regulators (numbering starts at the top) will control the air to each of

your triple foam colors

• Insert your air lines to the arch into the bulkhead fittings on the bottom of the panel. The 3

, 4

, and 5

bulkhead

(counting from left to right) will be the airlines for each color.

5 Valve / 7 Regulator MD5 Panel

• Your triple foam has been setup from the factory to be in port 5

• Insert your triple foam manifold into position 5 with your selected injectors

already inserted

• On the side of the panel the 5

, 6

, and 7

regulators (numbering starts at the

top) will control the air to each of your triple foam colors

• Insert your air lines to the arch into the bulkhead fittings on the bottom of the

panel. The 5

, 6

, and 7

bulkhead fittings (counting from left to right) will be

the airlines for each color.

Note: Occasionally if all three regulators are pre-set too high, you may need to lower all three regulators to their

lowest setting and then turn them up to the desired pressure.