Installation Manual Instruction Manual

Installation Manual

- 6 -

Installation Instructions

General Skill Level

• Mechanical: Basic - mounting equipment

• Electrical: Advanced - three phase power and controls knowledge

(local codes knowledge required)

• Plumbing: Moderate – principal supply line required

• Pneumatic: Basic- pneumatic utility connection required

• Chemical Knowledge: Moderate : Advanced - chemical titrations required

Tools and Equipment Needed

• Drill with Phillips head

• Concrete drill bit 3/8”

• Concrete drill bit 5/32”

• Hammer

• Tape measure

• Level

• Utility knife

• Wire stripper

• Socket set

• Adjustable wrench

• Screw driver set

• Teflon tape

Unpacking

The AQUA-LAB is shipped in a wooden crate for protection.

1. Cut straps holding crate together, lift off top and sides

2. Un-bolt the Pump Stand from the pallet.

3. Lift the Pump Stand from the pallet. Use assistance if

necessary.

4. ***Be sure not to discard of the manuals and accessories

box.

Location and Mounting

**If location was not identified during the Pre-Installation Process, make

sure to consider the proximity to feed water, power supply, and the control cabinet as well as space near the system to

store chemical containers.

***See drawing in appendix for general layout

AQUA-LAB MD5

1. Drill 4 5/32” holes on the wall. 16

3/8”

wide, 27

5/8

” tall

2. Press MD5 board tight against the wall.

3. Screw in 3/16” concrete screws with a washer provided.