Installation and Operating Manual

Operating Manual
© Hydra-Flex Inc 2011
- 1 -
Specifications
1. Operating water pressure: 200 psi (Factory set)
2. Pneumatics operating pressure: 100 psi Max Feed
3. Maximum water source temperature 140° F
4. Operating ambient temperature: 40-120° F
5. Signal – No signal from Car Wash Controller required
6. Electrical supply
a. 120/208-230VAC (1-phase) – 8 foot cord included
b. 3/4 hp pump 10 amps @ 120 volts or 5 amps @ 208 volts
7. Water supply
a. 50 micron filtration or better recommended
b. ½” OD Poly Flow or 3/8” ID Hose
c. Inlet pressure: Flooded-80 psi
i. If pump is fed from tank, water level must be ~28” above pump.
8. Air supply
a. 3/8” feed per system
b. 20 CFM @ 100 psi supply
9. Solution Outlet lines
a. ½” poly lines(3/8” ID)
b. Max pressure of outlet line is 66psi
10. Space requirement: 20” L x 12” W x 16”H
11. Weigh ~45lbs
Illustration