Manual

GSM Radio Module CSI-F-10 Page 111
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
10.1 Overriding Error Messages
10.1.1 Function not Available in this Mode
The CM program has been compiled for a platform in which the marked function does
not exist.
► Check the platform setting and correct it or modify the CM program accordingly.
10.2 Error Messages with Data Sources
10.2.1 Invalid Channel Setting
A channel/subchannel has been selected that is not valid.
► Check the channel setting and correct it.
10.2.2 Duplicate Channel Name
The name of a channel may only be used once in a CM program.
► Check the channel name and correct it.
10.2.3 Invalid Digital Input
A port must be set for the digital input function.
► Check the port setting and correct it.
10.2.4 Duplicate Digital Input
A port must be set for the digital input function. This set port may only be used once
in a CM program.
► Check the port setting and correct it.
10.2.5 Too many Boolean Input Fields
A maximum of 50 Boolean input values are permitted to be present in a single CM
program.
► Reduce the Boolean input values to a maximum of 50.
10.2.6 No Inscription for Boolean Input
The Boolean input value must have an inscription.
► Enter an inscription in the function properties.
10.2.7 Duplicate Inscription for Boolean Inputs
The inscription of a Boolean input value must be unambiguous within a CM program
and is only permitted to occur once for that reason.
► Check the inscription and correct it.
10.2.8 Too Many Numerical Input Values
A maximum of 50 numerical input values are permitted to be present in a single CM
program.
► Reduce the numerical input values to a maximum of 50.