User guide

ContaminationSensor CS1000 CS1000 Features
HYDAC Filtertechnik GmbH
en
Page 16 / 100
BeWa CS1000 3247149n en 2009-02-04.doc 2009-02-04
CS1000 Features
The CS1000 Series ContaminationSensor is a stationary measurement unit for the
continuous monitoring of solid particle contamination in hydraulic and lubrication
systems.
The CS is designed to be used in low- or high-pressure hydraulic and lubrication
circuits and test benches where a small amount of oil (between 30 ml/min and 300
ml/min) is diverted for measurement purposes.
The ContaminationSensor is approved for a maximum operating pressure (see
specification on type label) and viscosity of up to 1000 mm²/s.
The particulate contamination is recorded by an optical measurement cell.
The sensor is available with the following options:
• with or without 6-digit display and keypad (can be rotated by 270°)
• with a 4 - 20 mA or 0 - 10 V analog output
• results are output as a cleanliness code according to:
ISO 4406:1999 and SAE AS 4059(D) or
ISO 4406:1987 and SAE AS 4059(D) or NAS
• pipe / hose installation or flange installation
All models feature an analog output and an RS485 interface for outputting the
measured cleanliness class. They also have a switch output set to switch at either
increasing or decreasing cleanliness.
CS1000 Restrictions on use
NOTICE
Prohibited operating fluids
The CS will be destroyed.
 Operate the CS1000 only in conjunction with the permitted operating fluids.
 CS 1xx0 is suitable for operation with petroleum or petroleum-based
refinates.
 The CS 1xx1 is suitable for phosphate esters.
 Observe the maximum operating pressure on the CS 1000 type label.