User guide

Condition Monitoring Unit CMU 1000 Page 23
Revised 17.12.2009 HYDAC ELECTRONIC GMBH Mat.-No.: 669749
5 Basic Settings/Menu Structure
The CMU 1000 configuration and settings can be carried out in two different modes:
5.1 Configuration on the Device
5.1.1 Menu Structure for Operation on the Device
Level 1 Level 2 Level 3 Level 4 Level 5 Level 6
Sensor A
[Display of current
measured value]
Sensor B
:
[Display of current
measured value]
Input values
:
Sensor R
[Display of current
measured value]
Name [Enter name]
Language
German
English
French
Port RS 232 / HSI
Dateformat
TT.MM.JJ
MM/TT/JJ
JJ-MM-TT
Delete record
Yes /
No
Recording settings
Continue record
Yes /
No
HLB reset
Yes /
No
HLB reset
Sensor
Sensor A …
Sensor H
Date
[Enter
current date]
Time settings
Time
[Enter
current time]
IP-Address
[enter
IP address]
Subnetmask
[enter
subnetmask]
Gateway
[enter
Gateway address]
Basic settings
Network settings
MAC-Address
[MAC address
is permanently
set at the factory]
Numerical input
values
[Enter value]
CM Program
settings
Boolean input
values
Yes / No
The menu option appears only if one
or more input functions are used in
the CM Program!
Channel A
:
Channel H
Name
[Enter
name]
Name
[Enter
name]
Mode
Automatic
Off
Manual
Input signal
HSI
0 .. 20 mA
4 .. 20 mA
0 .. 5 V
0 .. 10 V
0,5 .. 4,5 V
0,5 .. 5,5 V
1 .. 5 V
1 .. 6 V
Settings
Peripherals
Channel settings
Channel I
:
Channel P
Low
range
[Enter
value]