Installation Instructions for Hy-dit ® Toilet Plunger Storage English Patent # 7,156,476 B2 Manufactured by: 710 Independent Ave • Grand Junction, CO 81505 • 970-523-6935 / 523-4707 fax
Hy-dit ® Complete Assembly Drawing List of parts: 1 – Hy-dit® box 1 – Door 1 – Drip tray 2 – Hinge pins 6 – Plastic anchors 1” 6 – Anchor screws #10 x 1” 1 Toiler plunger w/ handle 1 Toilet brush 1 Pattern for cutting drywall Figure 1 Tools needed for installation: Phillips screwdriver Drywall saw (preferred) or utility knife Level 13/64” drill bit Drill Hammer Small nail
Step 1 Find Installation Location between Studs: Once a desired location has been chosen, the next step is to make sure there is no electric, plumbing or heat ducts in your way. • Electric: Make sure there are no electric outlets in the area that has been chosen. Check the opposite side of the wall as well; this may be in an adjacent room. • Plumbing: The plumbing is usually confined to the space behind a toilet or behind the tub/shower faucet.
Step 2 Trace Pattern & Cut Out Opening Once the pattern has been moved to the last hole where a stud was not hit and leveled continue making small nail holes to the other edge of pattern (see fig. 2). If no stud is hit trace the pattern on the wall and continue. If a stud or any other obstacle was hit a new location will be necessary. Patch small holes and restart at step 1. Once the pattern has been traced on the wall use a drywall saw (preferred) or a utility knife to cut out the opening.
Step 3 Installation of Box Install and level box in the opening. Mark the centers of the six mounting screws (see fig 3). Remove box to drill out marked holes using a 13/64” drill bit. If holes are over a stud do not drill or use a plastic anchor. Install plastic anchors in drilled holes; tap lightly so the anchor head is flush with drywall. Reinstall box using the #10 x 1” screws, either into the plastic anchors or directly into the stud.
Installation of door Align top and bottom hinge of door with top and bottom hinge of box (see figure 1), either the right side or the left depending on desired swing. Install top and bottom hinge pins. Finish door For painting or staining, prep the area to be finished with a light sanding. Use lightly a 220 grit sand paper to remove the factory sheen. • For painting; 1st apply an approved primer then paint with compatible paint.
