Instructions / Assembly
7
Cleaning with Non-Rotary Attachments
Remove and Rinse Cleaning with the
Gutter Brush
and
Gutter Scoop
Attach Grip Handle to end of base pole
section facing up as shown
Step 1. Determine Type of Build-up
in Gutters
> Refer to page 4
Step 2:
Connect as many pole sections as
needed to reach desired gutter height.
Note:
A 6 ft. Extension Kit is available
and sold separately.
(Items: VXT006/GSX906)
Step 3:
Attach the Gutter Brush or Gutter Scoop to the curved tube section at an angle
and direction best suited for your cleaning method.
Step 4:
Install Grip Handle at the very bottom of base pole section facing up (See
photo at left). This gives you much more control as you apply a twisting motion
while lifting the debris up and out of gutter.
Step 5:
It’s recommended that you start cleaning the gutter from the down spout end and
drag the debris away from the downspout. This helps prevent excessive debris
from falling into the downspout.
Helpful Hints:
> On windy days, work in the same direction as the wind (with the wind).
This will prevent the leaves from blowing toward you as you drag and lift
them out of the gutter.
> Angle the Gutter Brush or Gutter Scoop slightly away from you while
cleaning to help prevent the debris from falling toward you.
Step 6:
As you drag the Gutter Brush or Gutter Scoop down the gutter, stop
occasionally to remove the debris. Remove the debris by tilting the tool back
slightly and push into the debris as you lift the debris up and out of the gutter.
Twist the poles as the debris lifts out of the gutter to help drag away from
gutter
opening.
When you reach a gutter support, lift as much debris out of the gutter as
possible and then push remaining debris under and past support.
Lift the Gutter Brush or Gutter Scoop up and over support. While lowering back
into gutter, angle the brush back under support to grab debris then continue the
drag and lift process.
W
ARNING
Hazard
of
Electric
Shock
or
Bur
n!
The
extension
poles
and
all
other par
ts
of the
GutterSweep
System
or
Extension
Kit
are
NOT
to
be
used
ON
or
NEAR
electrical
wiring
of
an
y
type.
K
eep
at
least
10
feet
(3
meter
s)
a
w
a
y
from
an
y
pow
er
lines.
Use
extreme
caution
when
raising
,
low
ering
or
while
wor
king
with
the
GutterSweep
T
ools
and
Extensions.