Instructions / Assembly

6
Rotary Gutter Cleaning (cont.)
Step 2. Cleaning Around Gutter Supports:
Important Note: Use caution while spinning Paddle Brush near gutter supports. Operate drill at half speed or less especially
while cleaning under supports.
1) Clean completely under the support until the Curved Tube makes
contact with the gutter support.
2) Pull the Paddle Brush back slightly and lift up and over gutter support.
3) Lower the Paddle Brush back into the gutter and continue cleaning.
Step 3. Collect Debris on Tarp and
Dispose: It’s best to clean the ground area before
rinsing the gutter clean with water.
Step 4. Rinsing the Gutter:
Remove the Right Angle Gear Assembly with Paddle Brush from the curved tube and
attach Gutter Brush.
Remove Drill Adapter from bottom pole section. Connect garden hose to Water Control
Valve then connect Water Control Valve to bottom pole section. Use the Gutter Brush
with built in water jet nozzle to rinse the inside and outside of the gutter clean.
Built-In Water Jet Nozzle