Instructions / Assembly

4
Getting Started
Assembling Tool for Rotary Gutter Cleaning
Step 1. Connect Pole Sections:
> Loosen coupling nut slightly on lower pole section (Do Not Remove Coupling Nut).
> Depress button on pole to be connected and slide into Coupling. Be sure upper pole section
is locked into place by rotating section until button locks into sleeve.
> Hand tighten threaded coupling nut.
Step 2. Attach Curved Tube:
> Connect Curved Tube by sliding into top pole section using the same method as described
above. Be sure curved tube is locked into place by rotating section until button locks into
sleeve.
> Hand tighten threaded coupling nut.
Step 3. Attach Right Angle Gear Assembly:
> Depending on direction of cleaning, right to left or left to right, connect the Right Angle Gear
Assembly to the Curved Tube at desired angle by inserting into Curved Tube then hand
tighten coupling nut securely.
Note: To help prevent debris from falling near or on you, angle the gear assembly slightly away
from you instead of at a right angle.
Step 4. Attach Rotary Paddle Brush:
> Align spring button on right angle gear shaft with hole in paddle brush then press onto shaft.
Be sure spring button locks into hole on paddle brush securely.
Step 5. Attach Grip Handle:
> Open the hinged handle clamp by loosening thumb screw
completely.
> Attach Grip Handle around bottom pole section by closing
clamp around pole using thumb screw.
> Position handle for best control and comfort then tighten
securely by hand.
Step 6. Attach Drill Adapter:
> Slide Drill Adapter onto bottom pole section until adapter
locks securely with spring button of lower pole section.
Step 7. Connect Your Cordless Drill:
> It may be easier to raise the assembly and rest it in the
gutter before attaching your drill. Once resting in gutter,
insert shaft of Drill Adapter into chuck of cordless drill and
tighten securely.
> Be sure to set clutch/torque adjustment on drill to a mid-
range setting.
Operate at a moderate speed (1/2 speed or approx.500 RPM)
Note: The Drill Adapter can also be attached to cordless drill
first, then connected to bottom pole section while tool is resting
in gutter.
NOTE:
> Connect additional pole sections for higher reach
> 6 ft. Extension Kit sold separately—
(Item # VXT006 or GSX906)