User's Manual

Note: for the Patroller unit (whether mobile or USB) to detect the logger, the radio

frequencies of Patroller or USB transceiver must match.

Note: some sections will appear blank (locations, GPS, Address etc). This is because

the loggers have not been configured with these details (see section Deploy on how

to configure).

Note: if the logger does not appear, try swiping the logger with a magnet along the

square ridge on the side of the case. Warning: Swiping the logger will invalidate

synchronisation for any sound recordings not yet downloaded.

More options and information from the loggers can be seen by clicking on File ->

Options, and selecting the information of interest. The checkbox “Colour-code

loggers” introduces a colour bar denoting leak (red) or no leak (green) detected.