User's manual

Cracks in the insulation have no effect on the efciency of the stove. The insulation should be replaced,

however, when it is reduced to less than half the original thickness due to wear and tear.

HWAM Autopilot™ (Drawing G)

Lift the top plate off the stove. Remove the rear plate by loosening the two screws. On a cold stove,

the starting point of the feeler is controlled. The starting point for a cold stove is approx. 20° above

horizontal (at laser cut mark).

It should feel easy going and bouncy when you push it, no matter if the stove is cold or hot. By rising or

falling temperatures it must not move at a bound. The damper plates must be dry and clean and slide

together unhindered. Control bars and slide gates may have to be smeared with WD40 (never oil).

Door/glass

A sooty glass door can easily be cleaned with a piece of moist kitchen roll dipped in ash. Go about it in

vertical movements (up and down). Follow up with a dry piece of kitchen roll. Check frequently to ensure

that seals in the door are intact and not brittle. Failing this, they should be replaced. Use original seals only.

Surface

The surface normally requires no treatment. Any damage to the coating may be remedied using a

Senotherm spray.

Guarantee

The guarantee does not cover damage due to insufcient maintenance!

operaTional problemS

Blackened glass

• The wood is too damp. Only use wood stored for at least 12 months under cover and with a moisture

level not exceeding 18% RH.

• The door gasket may be leaking.

Smoke in the room when opening door

• The grate in the chimney may be closed. Open the grate.

• Insufcient chimney draft. See section on chimney or contact chimney sweep.

• Soot door leaking or dislodged. Replace or ret.

• Never open the door when there are still ames on the wood.

Uncontrollable combustion

• Faulty seal in door. Fit new seal.

• If there is an excessive chimney draft, it may be necessary to close the regulating rod. Close the

regulating rod when the stove is not in use.

• If the steel plates in the combustion chamber develop scales or become deformed, this is due to exces

sive heat. Stop using the stove and contact the dealer.

At interruptions that you cannot yourself rectify, you should contact the dealer.

deClaraTion oF perFormanCe

The DoP can be downloaded from our website via the following links: