User's manual

45
and the embers are glowing in a circle around the shaking grate. Put at least two pieces of wood into
the stove, weighing up to 1 kg each. Do not regulate the stove again as the Autopilot system will do this,
but the temperature can be adjusted with the regulating rod (1). Moving it down will reduce the rate of
combustion and the stove will burn slower. Moving it up will increase the temperature and the stove will
burn faster. Wait until the layer of embers is suitably low before stoking again.
Fuelling with coal, wood briquettes or pet coke
The stove is not approved to use coal or pet coke as a fuel. However, wood briquettes can be used to
fuel the fire and should be placed on the embers produced by the burned wood. Move the regulating rod
to top position until the briquettes are glowing uniformly.
Remember that after this the regulating rod must be closed again. Be aware that using fuels
other than wood, will cause soot to form on the glass pane.
Operating the heat compartment damper
There is a damper at the back of the stove between the top plate and the heat compartment that opens
and closes the flow of convection air in the heat compartment. The supply of convection air can be opened
by moving the damper to the left and closed by moving the damper to the right.
We recommend that the convection damper is kept closed when fuelling the stove in order to heat up
and thereby store heat in the heat storage stones in the heat compartment as rapidly as possible.
Keeping the convection damper closed retains the heat stored in the heat storage stones as long as pos
-
sible. When the damper is opened, the heat from the heat storage stones in the heat compartment will
rapidly be transferred to the room.
FIrIng In general
Rapid or fierce heat
Rapid or fierce heat is obtained by burning many small pieces of wood.
Maximum amounts of fuel:
The maximum allowed amount of fuel per hour is:
Wood: 2.5 kg
If these limits are exceeded, the stove will no longer be covered by the factory guarantee, and it may also
become damaged due to excessive heat. The stove has been approved for intermittent use.
Typical re-firing interval
Typical re-firing interval at nominal performance
Wood: 65 min
Prolonged burning time
Long combustion is achieved by burning a few (at least two) large pieces of wood and adjusting the
regulating rod to a lower level.
The slowest combustion is achieved by pushing the regulating rod to its lowest position (drawing E, item
1). However, with the regulating rod in this position, it may be difficult to keep the flames alive after
refuelling. If so, it will help to adjust the regulating rod to about 1/5 for the first 25 minutes or so after
refuelling. The stove can then be adjusted to minimum again. Remember that there must be visible flames
for proper combustion to take place.