User's manual
14
Ashes
The ash pan is best emptied by pulling a waste bag over the pan, tipping it and then carefully pulling it out
of the bag. Ashes are disposed of via the domestic waste collection.
Please note that there may be embers in the ashes for up to 24 hours after the fire has
gone out!
Insulation
The efficient, but porous insulation of the combustion chamber may, in time, become worn and damaged.
Cracks in the insulation have no effect on the efficiency of the stove. The insulation should be replaced,
however, when it is reduced to less than half the original thickness due to wear and tear.
HWAM Autopilot (Drawing G)
Lift off the rear panel. On a cold stove, the starting point of the feeler is controlled. The starting point on
a cold stove is about 30
0
above horizontal.
It should feel easy going and bouncy when you push it, no matter if the stove is cold or hot. By rising or
falling temperatures it must not move at a bound. The damper plates must be dry and clean and slide
together unhindered. Control bars and slide gates may have to be smeared with WD40 (never oil).
Door/glass
A sooty glass door can easily be cleaned with a piece of moist kitchen roll dipped in ash. Go about it
in vertical movements (up and down). Follow up with a dry piece of kitchen roll. Check frequently to
ensure that seals in the door and ash pan are intact and not brittle. Failing this, they should be replaced.
Use original seals only.
Surface
The surface normally requires no treatment. Any damage to the coating may be remedied using a Seno
-
therm spray.
Guarantee
The guarantee does not cover damage due to insufficient maintenance!